HIGH FLOW PC+ABS

PHYSICAL PROPERTIES

Typical Properties	^{Typical Value}	^Standard
Specific Gravity	1.12	ASTM D 792
Water Absorption, 24 hours @ 73⁰F	0.1 %	ASTM D 570
Water Absorption, Equilibrium, 73⁰F	0.4 %	ASTM D 570
Mold Shrinkage, flow, 0.125"	0.5-0.7 %	3D-CAM Method
Mold Shrinkage, xflow, 0.125"	0.5-0.7 %	3D-CAM Method
Melt Flow Rate, 230⁰C/3.8 Kgf	7 g/10 min	ASTM D 1238
Melt Flow Rate, 260⁰C/5.0 Kgf	24 g/10 min	ASTM D 1238

MECHANICAL PROPERTIES

Typical Properties	^{Typical Value}	^Standard
Tensile Stress, Yield, Type l, 2.0 in/min	8400 psi	ASTM D 638
Tensile Strain, Yield, Type l, 2.0 in/min	5 %	ASTM D 638
Tensile Strain, brk, Type l, 2.0 in/min	80 %	ASTM D 638
Tensile Modulus, 2.0 in/min	360000 psi	ASTM D 638
Flexural Modulus, 0.05 in/min, 2 in span	360000 psi	ASTM D 790
Flexural Stress, yld, 0.05 in/min, 2 in span	13200 psi	ASTM D 790
Izod Impact, Notched, 73⁰F	10 ft-lb/in	ASTM D 256
Izod Impact, notched, -22⁰F	2 ft-lb/in	ASTM D 256
Instrumented Impact Total Energy, 73⁰F	480 in-lb	ASTM D 3763
Instrumented Impact Total Energy, -22⁰F	360 in-lb	ASTM D 3763

THERMAL PROPERTIES

Typical Properties	^{Typical Value}	^Standard
HDT, 66 psi, 0.125", unannealed	240°F	ASTM D 648
HDT, 264 psi, 0.125", unannealed	210°F	ASTM D 648
CTE, flow, -40°F to 100°F	4.E-05/°F	ASTM E 831
Thermal Conductivity	0.2 W/m-°C	ASTM C 177

this is text meant just to take up lots of space at the bottom of the page, so that if there is only a table or something in the content part of this page, the content still takes up the majority of the screen. if there is not any text here, then sometimes there will be just a table here, and the left navigation bar to the left will be kinda wide...